Mallory-ignition ACCEL ULTRA PERFORMANCE HEI MODULE WITH REV CONTRO Manual do Utilizador descarregar pdf

ULTRA PERFORMANCE HEI MODULE

WITH REV CONTROL

PART NO. 35373

INSTALLATION INSTRUCTIONS

FORM 1561A 12/04

The ACCEL #35373 HEI Module is designed to

replace the entire 4 pin GM module and

connector/harness assembly in GM 4, 6 (even-fire),

and 8 cylinder HEI distributors. Only the GM

pickup/stator assembly will remain of the original

triggering system.

For optimum performance, use either ACCEL

#140013 or #140015 Brute Thunder SuperCoil in

street and racing applications.

INSTALLING THE MODULE-

1. After removing the cap and rotor assembly,

disconnect the 2 wires from the pickup/stator

assembly, remove the mounting screws, and

remove the GM 4 Pin module, connector/harness

assembly that it plugged into as an assembly.

2. Clean off the pad area of the distributor housing.

Use a surface or contact cleaner that leaves no

residue.

3. Put an even coat of the supplied heat sink

grease across the entire aluminum heat sink of

the module.

4. Place the module into position into place,

inserting the wiring harness into the notch in the

housing and snug the mounting screws down.

This will even out the grease film. Do not tighten

completely yet.

5. Use the supplied 8-32 screw to hold down the

back end of the circuit board. Once this screw

has been started into the threads, tighten the two

module screws down snugly. DO NOT overtighten!

Once these two screws have been tightened, then

tighten the remaining screw at the end of the PC

board.

6. Connect the two wires from the pickup/stator

assembly to the 2 spade terminals on the circuit

board. Note that there are two different terminal

sizes!

7. Select the number of cylinders using the 2 bottom

switches as shown in the diagrams below.

ACCEL IGNITION www.accel-ignition.com

4 CYLINDER 6 CYLINDER 8 CYLINDER

1 2

Resumo do Conteúdo

Página 1 - WITH REV CONTROL

ULTRA PERFORMANCE HEI MODULEWITH REV CONTROLPART NO. 35373INSTALLATION INSTRUCTIONSFORM 1561A 12/04The ACCEL #35373 HEI Module is designed toreplace t

Página 2 - 2 www.accel-ignition.com

2 www.accel-ignition.comACCEL IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144216.688.8300 FAX 216.688.830

Comentários a estes Manuais

Sem comentários

Mallory-ignition ACCEL ULTRA PERFORMANCE HEI MODULE WITH REV CONTRO Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Para o carro Mallory-ignition ACCEL ULTRA PERFORMANCE HEI MODULE WITH REV CONTRO. Mallory Ignition ACCEL ULTRA PERFORMANCE HEI MODULE WITH REV CONTROL 35373 User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Para o carro Mallory-ignition ACCEL ULTRA PERFORMANCE HEI MODULE WITH REV CONTRO